SELECT Control. When tuned to an HD Radio
TM
HD-1 signal and at least one multicast broadcast is
present, i.e., HD-2 through HD-8, momentarily depressing the SELECT switch puts tuner into multicast
tuning mode, and automatically tunes the tuner module to the first multicast broadcast available. Use
the UP control to scroll through all of the multicast stations available. Use the DN control to exit
multicast tuning mode and re-tune to the HD-1 signal.
When selected tuner module has acquired any station in TUNER BAND mode and SELECT switch is
held for three seconds, tuner goes into PRESETS store mode; PRESETS arrow LED flashes. UP and
DN controls then allow user to scroll through the previously stored stations in positions A1 through A20
or F1 through F20, dependant on band. Inter-station audio muting is active while tuning between
preset stations. Next momentary push of SELECT switch stores selected station in that PRESETS
position.
PRESETS Control. In PRESETS tuning mode, the tuner has the capability to store 20 AM stations
and 20 FM stations per tuner module – for a total of 120 stations.
Preset stations are stored for recall in positions A1 through A20 and F1 through F20 respectively for
AM and FM bands. When selected tuner module is in TUNER BAND mode and PRESETS switch is
momentarily depressed, tuner goes into PRESETS mode; PRESETS Arrow LED will illuminate when
the tuner is in PRESETS tuning mode. UP and DN scroll through the preset stations stored for the
band selected. Second momentary push of PRESETS switch toggles between AM and FM tuner
bands. To switch out of PRESETS mode and select manual tuning, momentarily depress TUNER
BAND switch.
HD Radio
TM
AM - VFD Sample Display for WATT-AM stored in preset position A9
MODE - SERVICE – Momentary push activates MODE – SERVICE menu. Blue arrow LED illuminates
only when switch is being pushed, or when MODE – SERVICE menu is active. In any active mode,
second push of MODE – SERVICE at any time clears mode. Use the UP or DOWN switches to change
the selection and press SELECT to enable the selection.
Comments to this Manuals